Modular Microphone Components
Showing 1–20 of 46 results
-
-
Modular Microphone Components
Schoeps CCM 4VP Microphone Capsule
Features
• cardioid pattern, side-adressed
• for pickup of speech or music at close range (under 20 cm)
• moderate low frequency attenuation
• preferred applications: close speech pickup, also available in the HSC 4VP headsetSKU: CCM 4VP -
Modular Microphone Components
Schoeps CCM 4VXP Microphone Capsule
Features
• cardioid for lateral pickup
• for pickup of speech or music at close range (under 10 cm)
• strong attenuation of low frequencies
• preferred applications: close speech pickup, also available in the HSC 4VP headsetSKU: CCM 4VXP -
-
Modular Microphone Components
Schoeps CMC 1 L Colette Microphone Amplifier
Features
• Variant of the CMC 1 U with miniature Lemo output connector
• K 5 LU (5 m cable with XLR-3M plug) and SGC stand adapter are included
• Fully equal alternative to the well-known CMC 6
• Compatible with all available MK capsules and active Colette accessories, e.g. CUT 60 or RC
• Compatible with all accessories of the CCM series, e.g. TR L oder STA
• Recommended accessories for boom use are the same as for CCM microphones, e.g. MINIX CCM LU or Rycote INV-5.SKU: CMC 1 L -
Modular Microphone Components
Schoeps CMC 1 U Colette Microphone Amplifier
Features
• Complete alternative to the renowned CMC 6
• Fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes
• Suitable mounting accessories are already available, such as the CINELA E-OSIX-CMC1U and the Rycote INV-6 elastic suspensions.SKU: CMC 1 U -
Modular Microphone Components
Schoeps CMC 6 U Colette Microphone Amplifier
Features
The CMC 6 is our most popular amplifier.
Its electrical properties have set new standards in terms of low distortion levels and common mode rejection (i.e. suppression of interference induced in the microphone cable).SKU: CMC 6 U -
Modular Microphone Components
Schoeps CMC 6XT U Colette Microphone Amplifier
Features
• The CMC 6xt is the HiRes version of the CMC 6.
• Using this amplifier, the frequency range of all axially-addressed capsules (MK 2 H/S, 21, 22, 4, 41, 5) can be extended up to 40 kHz
• Especially useful when recording with a high sample rate, particularly with the intent to slow down the recording and reduce its pitch by one or more octaves at a later point (e.g. for sound design)SKU: CMC 6XT U -
Modular Microphone Components
Schoeps CMR Colette Microphone Amplifier
Features
• Amplifier for pocket transmitters without phantom power
• ATTENTION: there are a limited number of compatible transmitters, including Sennheiser, Wisycom and others, see Downloads. Use with digital transmitters is not intended, as interference may occur.SKU: CMR -
Modular Microphone Components
Schoeps CUT 60 Low-Cut Filter for Colette Series Microphones
Features
• recommended for use with the MK 41 on a boom
• can be screwed between MK capsules and CMC amplifier
• very effective suppression of low-frequency wind noise and solid-borne noise
• extremely steep filter (24 dB/oct.)
• The speech signal is not affected.SKU: CUT 60 -
Modular Microphone Components
Schoeps KC 10 Active Colette Cable (10m)
Features
• cable for insertion between the capsule and the amplifier of the Colette system
• contains active electronics for impedance conversion of the capsule
• 3 mm thin, robust, tear-resistant cable
• a special sheath makes the cable torsion-proof, meaning that the hanging cable does not lose its orientation even when the ambient temperature rises.
• Signal transmission to the microphone amplifier is conducted asymmetrically, so the length should be less than 20mSKU: KC 10 -
Modular Microphone Components
Schoeps KC 5 Active Colette Cable (5m)
Features
• cable for insertion between the capsule and the amplifier of the Colette system
• contains active electronics for impedance conversion of the capsule
• 3 mm thin, robust, tear-resistant cable
• a special sheath makes the cable torsion-proof, meaning that the hanging cable does not lose its orientation even when the ambient temperature rises.
• Signal transmission to the microphone amplifier is conducted asymmetrically, so the length should be less than 20mSKU: KC 5 -
Modular Microphone Components
Schoeps MK 2 Microphone Capsule
Features
• linear frequency response at 0° (free-field equalized)
• for placement in close proximity to sound source
• preferred usage: close-miking instruments
The linear frequency response of the MK 2 with respect to frontally incident sound waves results in a very natural sound for near-field recordings (i.e. in close proximity to the sound source).
This capsule can be set up very close to the sound source without sounding too brilliant or harsh.SKU: MK 2 -
Modular Microphone Components
Schoeps MK 21 Microphone Capsule
Features
• wide cardioid
• preferred uses: as a soloist microphone or main microphone
• extremely consistent polar response leads to a very natural sound
• combines the advantages of the omni (warm sound) and the cardioid (directivity)
• popular as a main microphone pair e.g. at a spacing of 30 cm, angle +/- 45°SKU: MK 21 -
Modular Microphone Components
Schoeps MK 22 Microphone Capsule
Features
• New directional pattern: Open Cardioid
• Optimal combination of directionality (MK 4 cardioid) and warm sound characteristics (MK 21 wide cardioid)
• Natural sound quality, due to highly consistent polar diagram across the frequency range
• PopFeaturesular for use as a spot or soloist’s microphone, as the mid microphone for M/S, or as a main microphone pair e.g. at a spacing of 21 cm, angle +/- 55°SKU: MK 22 -
Modular Microphone Components
Schoeps MK 2H Microphone Capsule
Features
• mild high-frequency response elevation at 0°, which compensates high frequency losses caused by a slightly increased diffuse field amount at medium recording distance
• ideal for A/B stereophony and Decca Tree
The gold-plated ring reduces the size of the acoustic opening of the MK 2H. This results in an acoustic elevation above 6 kHz. The MK 2H is a capsule often described as balanced and round. Together with the KA 40 sphere accessory, it forms a classic Decca Tree capsule.SKU: MK 2H -
Modular Microphone Components
Schoeps MK 2S Microphone Capsule
Features
• moderate high-frequency response elevation at 0°, which compensates high frequency losses caused by the increased diffuse field amount when used near the reverberation radius
• often used for A/B stereo, Decca Tree or as a room microphone
The MK 2S is our most popular pressure transducer.
It’s somewhat brighter sound (compared to the MK 2 and MK 2H) makes it ideal for use as a main microphone or room microphone, especially in larger rooms.SKU: MK 2S -
Modular Microphone Components
Schoeps MK 2XS Microphone Capsule
Features
• diffuse-field equalized (considerable high-frequency response elevation at 0°)
• for use at relatively great distance from the sound source
• preferred use: as a room microphone
The MK 2XS compensates for high-frequency response losses and thus has flat frequency response in the diffuse sound field. If used near a sound source, the sound is brilliant.
The MK 2XS is usually used as a room microphone beyond the reverberation radius.SKU: MK 2XS